Viking Video Entry Phone with Keypad

The K-1705-3 provides a tough and attractive handsfree phone for apartment, and residential door/gate entry or applications requiring a vandal resistant speaker phone with built-in color CCTV video camera. When the “Call” button is pressed, the K-1705-3 returns dial tone. The keypad may then be used to dial any number. If no Touch Tone is entered within 8 seconds, CPC is detected, a busy signal is detected, or the programmable maximum call time has elapsed, the K-1705-3 will automatically disconnect. Alternatively, the K-1705-3 may be disconnected by pressing the “Call” button again. The K-1705-3 features a built-in high resolution color video camera, microphone and speaker volume controls, selectable auto answer for monitoring, a yellow “In-Use” LED and comes complete with a standard flush mount rough-in box. In addition, an optional VE-6x7 weather resistant surface mount box is available. For extreme outdoor environments or corrosive atmospheres, the K-1705-3 is available with Enhanced Weather Protection (EWP). EWP products feature rubber gaskets and boots, closed cell foam gasketing, hand soldered silicon sealed connections, anti-corrosive gel filled butt connectors, as well as urethane encapsulated circuit boards with internally sealed, field-adjustable trim POTS and DIP switches.

• Apartment entry phone when used with the K-1900-3 Apartment Entry Dialer or C-4000 Apartment/Office Entry Controller or C-3000 Apartment Entry Controller
• Residential gate or door entry phone when used with the C-2000A Door Entry Controller
• Courtesy and customer assistance phone
• Automated teller (ATM) phone
• Security or emergency phone
• Hot-Line phone when used with the K-1900-5 Hot-Line Dialer Note: When installing a line powered phone on a low voltage and/or low loop current phone system extension, a TBB-1A Talk Battery Booster may be required (Fax Back # 630).
• Kiosk phone with (100 number speed dialing) when used with the K-1900-9 Multi-Number Dialer

• Built-in high resolution color video camera with wide viewing, tilt/swivel adjustments and wide operating temperature of -30°F to 150°F
• Audio and video transmission on one CAT5E cable
• Vandal Resistant Features: 14 gauge louvered stainless steel faceplate with stainless steel speaker/mic screen, heavy duty metal keypad and “Call” button, impact and scratch resistant camera lens and hex drive mounting screws Weather Resistant Features: Mylar speaker, faceplate gasket, mic and speaker gasket, internally sealed (IP67) push button switch and keypad, sealed camera lens, potted camera circuit board, stainless steel phone and camera mounting hardware
• Optional Enhanced Weather Protection (EWP) conforms to NEMA requirements
• Yellow “in use” LED
• Volume adjustments for microphone and speaker
• Advanced call progress detection: disconnects on busy signal, return to dial tone, CPC reorder tone, maximum call time out and selectable silence time out
• Selectable auto-answer feature for monitoring
• Selectable push button disconnect
• Zinc plated steel rough-in box with (2) 3/4” conduit knockouts
• Optional VE-6x7 surface mount box available
• Selectable maximum call time
• Selectable VOX switching speed

• Power: Telephone line powered 20V DC/20mA minimum
• Dimensions: Overall: 140mm x 165mm x 66mm (5.5” x 6.5” x 2.6”) , Rough-in box: 114mm x 140mm x 64mm (4.5” x 5.5” x 2.5”)
• Shipping Weight: 1.6 kg (3.5 lbs)
• Speaker Volume: Approximately 70 db maximum @1m
• Ring Voltage: 25V AC RMS minimum (for auto answer)
• CPC Disconnect Time: 500ms minimum
• REN #: 0.5 A
• Power: 5-9V DC regulated 150mA (6V DC adapter included)
• Image Sensor: 1/4” color CMOS
• Video Output: 1 VP-P composite, NTSC, 75 ohms
• Resolution: 420 lines (640 x 480 @ 30fps / 307,200 pixels)
• Sensitivity: 0.26 LUX (20 IRE) F 2.0
• Lens: 3.4mm, pinhole 70° FOV (Field of View)
• Tilt/Swivel Adjustment: Vertical +/- 20°, horizontal +/- 30°
• Maximum Wire Run Length: 1000 ft with *RG59/RG6 for video and CAT5 for power (doubled pairs) and entry phone audio. 150 ft with CAT5E for video, power and entry phone audio
• Operating Temperature: -34° C to 65° C (-30° F to 150° F)
• Humidity: Standard model: 5% to 95% non-condensing, EWP model: Up to 100%
• Connections: Standard model: (3) gel-filled butt connectors (3M Scotchlok UR2) and 2-position terminal block, EWP model: (5) gel-filled butt connectors (3M Scotchlok UR2)