Satin Black Double Gang Entry Phone with Color Video Camera

The E-65 Series Video Entry phones are compact, weather and vandal resistant speaker phones designed to provide two-way handsfree audio communication and color composite video of who is at your door or gate. The E-65's compact size allows it to be mounted in a standard single gang electrical box. The E-65 is available in five different attractive finishes to match your door hardware, light fixtures, etc. Replacement E-65 faceplates (PNL65) can be purchased separately and are available in all five standard finishes.

The E-65 entry phones can share a single phone line with house or small business telephones when used with a Viking model C-200, C- 250 or C-2000B Entry Phone controller. The E-65 entry phones can also be connected to an unused analog station port (programmed for ring down) on a phone system or connected directly to a telephone line when used with a Viking K-1900-5 or K-1900-30 dialer.

The E-65 features a built-in high resolution color video camera, microphone and speaker volume controls, selectable auto answer for monitoring and intelligent call progress detection for automatic hang-up when the call is completed.

For outdoor installations where the unit is exposed to precipitation or condensation, the E-65 Series is available with Enhanced Weather Protection (EWP).

Door or gate communication, business delivery entrances,Use with a Viking C-200 or C-250 to control one E-65 on a single phone line,Use with a Viking C-2000B to control 1 to 4 E-65’s and door/gate control on a single phone line,Provide unique front and back door chimes and paging when used with a Viking SLP-1 or SLP-4 and C-2000B.

Residential, commercial and industrial door security Use with a Viking K-1900-5 or K-1900-30 for automatic speed dialing on telephone lines or analog PABX/KSU station ports,Use on any analog PABX station port with programmable ringdown capability.

Features

• Built-in high resolution color video camera with wide viewing, tilt/swivel adjustments, and wide operating temperature of -30° F to 150° F Audio and video transmission on one CAT5E cable Compact size: Front panel is the size of a typical double gang midsize wall plate Mounting: Flush mounts in a double gang electrical box (2.25” deep x 3.65” wide x 2.84” tall minimum) or surface mounts in a Viking model VE-5x5 (not included, see DOD# 424) for mounting to a wall, post or VE-GNP Gooseneck Pedestal (EWP recommended)
• Available in 5 standard faceplate finishes: Brushed Stainless Steel, Oil Rubbed Bronze, Polished Brass, Satin Black and Satin White PNL-65 faceplates: Replacement faceplates with matching screws available in all five standard finishes Vandal Resistant Features: 16 gauge polished brass or 18 gauge 304 stainless steel faceplate, 316 stainless steel push button, stainless steel speaker screen, scratch resistant powder coating, impact and scratch resistant camera lens, hex drive mounting screws
• Weather Resistant Features: Mylar speaker, faceplate gasket, mic and speaker gasket, internally sealed (IP67) push button switch, sealed camera lens, potted camera circuit board, stainless steel phone and camera mounting hardware and UV stable weather resistant powder coating (excludes E-65-SS) E-65-EWP is designed to meet IP66 Ingress Protection Rating (see DOD# 859) Blue LED helps locate the push button, indicate ringing and off-hook.
• Telephone line powered Microphone and speaker volume controls Programmable Intelligent call progress detection for automatic hang-up on CPC, silence, busy signal, or time out.
  
  Specifications
  
  Power: Telephone line powered. Minimum 18V DC talk battery voltage with a minimum loop current of 20mA. Loop current may be boosted on low current lines with a Viking model TBB-1B Talk Battery Booster (see DOD# 632).
  
  Dimensions: Faceplate: 123.8mm x 125.4mm x 4.3mm (4.875” x 4.938” x 0.17”), Phone: 72mm x 46mm x 42mm (2.84” x 1.8” x 1.65”)
  
  Speaker Volume: Approximately 62db maximum @ 1m
  
  Ring Voltage: 25V AC RMS minimum (for auto answer)
  
  CPC Disconnect Time: 300ms minimum
  
  REN: 0.8A
  
  Camera Specifications
  
  
  
  Power: 3.5-6V DC regulated 150mA (5V DC regulated adapter included)
  
  Image Sensor: 1/4” color CMOS
  
  Video Output: 1 VP-P composite, NTSC, 75 ohms
  
  Resolution: 420 lines (640 x 480 @ 30fps / 307,200 pixels)
  
  Sensitivity: 0.26 LUX (20 IRE) F 2.0
  
  Lens: 3.4mm, pinhole 70° FOV (Field of View)
  
  Tilt/Swivel Adjustment: Vertical +/- 20°, horizontal +/- 30° (see Diagram A)
  
  IR Compatibility: This camera is equipped with an OLP (Optical Low Pass) filter to maintain correct video color in outside applications. The standard camera is NOT compatible with IR illuminators. If IR illumination is required, you will need to replace the exisiting camera with a Viking model VCAM-1IR. For more information, see DOD# 190.
  
  Maximum Wire Run Length: 750 ft with *RG59/RG6 for video and CAT5 for power (3 pairs) and entry phone audio (1 pair). 150 ft with CAT5E for video, power and entry phone audio. * Note: RG59 or RG6 with solid center conductor and 95% bare copper braid shield.
  
  Entry Phone / Camera Specifications
  
  Operating Temperature: -34° C to 65° C (-30° F to 150° F)
  
  Humidity: Standard model: 5% to 95% non-condensing, EWP
  
  model: Up to 100%
  
  Shipping Weight: 0.55 kg (1.2 lbs)
  
  Connections: (5) gel-filled butt connectors (3M Scotchlok UR2) Recommended Electrical Box for Flush Mounting: Double gang with minimum inside dimensions of 2.25” deep x 3.65” wide x 2.84” tall (Allied molded 9331 or equivalent)
  
  Recommended Surface Mount Box: Viking model VE-3x5 (DOD# 424)